Table of Contents
Advertisement
DX Air Curtain
16
OWNER'S: CORRECT USAGE
•
When you use the air conditioner for the first time or when you change the SET DATA value, follow the procedure
below. From the next time, the operation displayed on the remote controller will start by pushing the
button only.
Preparation
Turn on the main power switch and/or the leakage breaker.
Push each button to select a desired operation.
•
When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
•
After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute, but it
is not a failure.
REQUIREMENT
•
While using the air conditioner, operate it only with
the leak breaker.
•
When you use the air conditioner after it has not been used for a long period, turn on the leakage breaker at least
12 hours before starting operation.
Start
Push
1
The operation lamp goes on , and the
operation starts.
Select an operation mode with the
2
"MODE
One push of the button, and the display
changes in the order shown as follows.
button.
" button.
button without turning off the main power switch and
3
Select air volume with "
One push of the button, and the display
changes in the order shown as follows.
•
When the air volume is "
volume differs according to the room
temperature.
•
In heating operation, if the room
temperature is not heated sufficiently with
VOLUME "
"
•
The temperature sensor senses
temperature near the suction air port of the
indoor unit, which differs from the room
temperature depending on the installation
condition.
A value of setting temperature is the
measure of room temperature.
("
mode).
4
Determine the set up temperature by
pushing the
Stop
Push
button.
The operation lamp goes off, and the operation stops.
31
Owner
" button.
" operation, select
" or "
" operation.
" is not selectable in the FAN
or
button.
", air
Advertisement
Table of Contents
