Advertisement
6 OPERATION
(The reference numbers below are those of the picture 01).
Switch on the machine pressing the on/off switch No.03.
Put the product to be processed onto the fixed table No.07 or onto the movable table
(optional) No.08, pushing it to the direction of the blade lined up by the cutting regulator
(optional) No. 12, maintaining the thickness of the slice desired.
When pulling back the product do not touch the blade avoiding disconnecting it from
the wheels.
Drop a little bit of water onto the fixed table to facilitate the slipping of the product.
7 COMPONENTS ADJUSTMENT
7.1 Pulley Belt (the reference numbers below are those of the picture 02):
The belt No.05 must be firmly fixed to prevent it from skiding. Do not tighten it too
much because it can wear out quickly.
To have access to the belt remove the screws with a screwdriver from the inferior
back lid and take it out.
With a screw-wrench No.02 loosen the screws No.01 turning it counter-clockwise.
To stretch out the belt you have to push the motor No.04 with the wood lever No.03 tightening
the screws.
IMPORTANT: The pulleys must be lined up.
Picture - 02
03
04
6
01
02
05
2 MAIN COMPONENTS
Picture - 01
01
02
03
04
05
06
07
08
01- Blade Calibrator Knob
02- Wheels Diameter 225 MSK / MSKL
03- ON/OFF Switch.
04- Frame.
05- Blade Guide.
06- Blade.( Width 1/2")
07- Fixed Table.
08- Complete Movable Table (Optional).
09- Staple.
10- Upper Door.
11- Complete Pusher (Optional).
12- Complete Cutting Regulator (Optional).
13- Lower Door.
14- Handle.
15- Locking Knob M8x30mm.
16- Handle f 1/2"-CRW.
09
10
14
16
15
11
12
14
13
02
Complete Scraper
3
Advertisement
