Advertisement
3 TECHNICAL DATA
Technical Data
Voltage
Frequency
Rating
Consuption
Height
Width
Depth
Net Weigth
Gross Weigth
Cutting Width
Cutting Heigth
* All machines are wired for voltage as ordered.
4 INSTALATION
The mini band saws have to be installed on a working surface with a recommended
heigth of 850mm. The surface length should be 120cm (with cutting regulator) or
70cm(without cutting regulator).
Grounding wire must always be connected.
IMPORTANT: Check the tension of the blade by turning the handle No.01
(picture 01) clockwise before operating it.
A = 700mm (Without Cutting Regulator)
A = 1200mm (with Cutting Regulator)
4
Table - 01
Units
MSK
[V]
110 / 220 (*) 110 / 220 (*)
[Hz]
50 or 60
[Hp]
0,5
[kW/h]
0,26
[mm]
930
[mm]
650
[mm]
600
[kg]
43
[kg]
52
[mm]
215
[mm]
250
A
5 PRE OPERATION
Check if the machine is firm, no movement is allowed on the supporting surface .
MSKL
Wash with warm water and soap all the food-contact parts, and wipe dry. To do it
proceed as follows (the reference numbers below are those of the picture 01):
50 or 60
a) First of all switch the machine off and disconnect it from the power source ;
0,5
0,26
b) Open the upper door No.10 and lower door No.13 by pulling the handle No.15;
930
c) Loosen the blade No.06 turning the handle No.01 or calibrator (optional)
650
clockwise and take it out from the upper and lower wheels No.02;
600
d) Take out the staples which are in front of the upper and lower wheels to be able to
43
pull them out;
52
e) Assemble the components following the inverse steps.
215
250
IMPORTANT: The blade must be well calibrated.
turning it clockwise to get the right tension of the blade. Keep the machine off to
adjust the cutting regulator.
700mm
Use the handle No.01
In case the machine is equipped
with the blade tension calibrator
(optional) the same as the handle
No.01, you must turn it until the
blade starts escaping, it means
that the blade has
the right
tension.
5
Advertisement
