Ethernet Configuration Commands
description
description
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Example
switchxxxxxx(config)# default interface gi1
Interface gi1 set to default configuration
To add a description to an interface, use the description Interface Configuration
mode command.
To delete the description of an interface, use the no form of this command.
Syntax
string
description
no description
Parameters
string
•
—The description of an interface. (Length: 0 to 32 characters)
Default Configuration
The interface does not have a description.
Command Mode
Interface Configuration (Ethernet, port channel) mode
Example
switchxxxxxx(config)# interface gi5
switchxxxxxx(config-if)# description SW#3
11
157