Advertisement
TURBINE
BRUSH
CARE
(SC T9200/T9200EM/T9200
EMK)
Before caring for the turbine
brush, be sure to turn OFF the switch of the unit and
disconnect
the plug from the outlet.
If needles pins or waste paper get stuck in the suction
inlet, remove them after going
through
the above procedure.
Trying
to remove them during operation
is dangerous.
HOW TO ADJUST
VOLTAGE
(SC 9200 EK/9200EMK/T9200
EMK)
The SC 9200EK,
SC 9200EMK
and SC T9200EMK
models operate
on either
11 OV
127V
or 220-
250V
current.
The unit
is set at 220-
250V
at the factory.
If 11OV-127V
current
is to be used,
adjust the plug/socket
in the following
manner:
CAUTION:
1.
2.
3.
4.
Model
SC 9200E,
SC 9200E-1,
SC 9200E-2,
SC 9200 EM, SC T9200,
SC T9200EM
and SC 50, SC 51, SC 50K
are not
equipped
with
adjustable
power
source plug/socket.
When the unit is set at 11OV-127V
do not use it with
a 220-
250V
power source.
Remove
this
screw
with
a screw
driver.
The
voltage
selector
plug is
fixed to this plate. (Fig. 1)
Pull out the plate with the voltage
selector plug attached
to it. (Fig. 2)
Remove
the plug and plug socket.
(Fig. 3)
Turn
around
the plug socket. Make
sure that these lines agree with each
other.
(Fig. 4)
ig. 2
~~
In case of 220-
250V
In case of 11OV-127V
outlet
s *O
9BF45-PII1-00519
S1
Printed
in Japan
@
@
Advertisement
