Toro 22615 Operator's Manual page 11

Figure 9
6. Raise the cutting wheel, release the parking brake,
and move the machine forward a few inches. Set the
parking brake.
7. Repeat steps 5 and 6 until you have completely
removed the stump (E through H in Figure 9).
8. Move throttle to the Disengage position, push the
handle down enough to raise the cutting wheel off the
ground. Wait for the cutting wheel to stop rotating
then release the parking brake and pull the machine
away from the stump.
Note: Do not let the front of the unit touch the
ground until you are sure the cutting wheel has stopped
turning.
9. Stop the machine; refer to Stopping the Engine (page
10).
11