Fujitsu LPF-4800 User Manual page 5

–– Be careful not to expose the projector to any steam, oily smoke, heat or humidity.
Never place the projector in a location subject to steam, oily smoke heat or humidity. This may cause fire or electrical shock.
–– Never place flammable objects such as a cigarette lighter, matches, gas canisters, spray cans, fireworks or plastic materials close to the
lamp ventilation holes. This may cause fire or other damage.
–– Always turn off the power switch before replacing the lamp. Allow the unit to cool off for at least one hour before replacing the lamp.
Replace the lamp according to the directions in the operation manual. Fire, burns or electrical shock may occur if the replacement is
performed incorrectly.
–– A laser beam is projected if the laser button in the accessory wireless remote control is pressed. Never look directly into the laser beam.
The laser beam may cause damage if it enters the eyes directly.
–– As there is the possibility that ozone (O
warnings listed in this operation manual.
–– Be careful to avoid condensation.
Dew or moisture condensation may be produced inside the projector if there are temperature differences between the inside and outside of
the unit. Make sure that the projector has warmed up to room temperature before using it. This condition may cause electrical leakage,
shock or fire.
–– Be careful when transporting the projector.
When transporting the projector, always remove the electrical plug and other cables. Be extremely careful to avoid dropping it or subject-
ing it to any shock or impact as this may cause fire or electrical shock.
–– Never touch the electrical plug with wet hands.
This may cause electrical shock.
–– Do not touch the lamp storage cover interlock mechanism.
Fire, electrical shock or other damage may occur if the interlock mechanism does not operate correctly.
–– This product should be operated only with the type of power source indicated on the label. If you are not sure of the type of power supply
to your home, consult your product dealer or local power company.
–– Use a plug with a ground terminal. This plug will fit only into a grounded power outlet. If you are unable to insert the plug into the outlet,
contact your electrician to install the proper outlet. Do not defeat the safety purpose of the grounded plug.
–– Use only the accessory cable designed for this product to prevent shock.
The power supply voltage rating of this product is AC 100 – 240 V, the power cable attached conforms to the following power supply
voltage. Use only the power cable designated by our dealer to ensure Safety and EMC.
When it is used by other power supply voltage, the power cable must be changed.
The included cable differs according to the model.
About the lithium battery
WARNING
–– Keep the lithium battery out of reach of children. Should the battery be swallowed, immediately consult a doctor.
CAUTION
–– Do not recharge, disassemble, heat or dispose of battery in fire.
–– Use a CR2025 (3 V) lithium battery only. Never use other types of battery with this product.
–– Do not handle the battery with metallic tools.
–– Do not store the lithium battery with metallic materials.
–– When disposing of used batteries, please comply with governmental regulations or environmental public institution's rules that apply in
your country/area.
–– Always check carefully that you are loading battery with its (+) and (–) poles facing in the proper directions.
3
) will be generated by the lamp power supply, handle the projector correctly according to the
Power supply voltage: AC 100 – 125 V
Power cable
AC 200 – 240 V AC 240 V
En-5