Bevel Gear Case And Axle Case - Toro Groundsmaster 4000-D Service Manual

Bevel Gear Case and Axle Case

The following procedures assume the rear axle assem-
bly has been removed from the machine (see Rear Axle
Assembly Removal in this section).
Bevel Gear Case and Axle Case Removal
1. Remove the mounting screws, nuts and lock wash-
ers. Remove the bevel gear case/axle case assembly
and O-ring from the axle support (Fig. 15).
2. Mark both right and left bevel gear case/axle case
assemblies.
IMPORTANT: Do not interchange right and left bev-
el gear case/axle case assemblies.
3. Remove the axle cover mounting bolts. Remove the
axle cover from the axle case as an assembly (Fig. 16).
4. Remove the axle case support mounting bolts, the
axle case support and the support shims (Fig. 17).
Groundsmaster 4000--D
4
35 to 41 ft- -lb
(47 to 56 N- -m)
1. Cap screw (4 used)
2. Lock nut (2 used)
3. Lock washer (2 used)
4. Axle support
1. Axle case
2. Axle cover assembly
Threadlocking
Compound
2
1. Axle case
2. Axle case support
Page 6 - - 17
35 to 41 ft- -lb
(47 to 56 N- -m)
1
6
2
3
Figure 15
5. Bevel gear case/axle
case assembly
6. O-ring
17 to 20 ft- -lb
(23 to 27 N- -m)
1
4
3
2
Figure 16
3. Bolt (6 used)
4. O-ring
3
57 to 67 ft- -lb
(77 to 91 N- -m)
4
1
Figure 17
3. Bolt (2 used)
4. Support shim
Axles, Planetaries and Brakes
5