Table of Contents
Advertisement
Power
Slow blink
Green
Slow blink
Green
Slow blink
Green
Off
Installing RF Security Sensors
Important
To prevent abuse and intrusion by unauthorized personnel, it is extremely important to install
Sensors such that it is difficult to unplug the devices from the network or from the power outlet.
For information on how to install the MSM325 Sensor or MSM320 with Sensor license, see the
MSM320 Quickstart. For controlled-mode operation, follow the directions through the end of the
Installation section. For autonomous-mode operation, follow the directions through step D of the
Initial Configuration procedure.
For information on how to install the MSM335 Sensor see the MSM335 Quickstart. For controlled-
mode operation, follow the directions through the end of the Installation section. For
autonomous-mode operation, follow the directions through step D of the Initial Configuration
procedure.
Installing the MSM415 Sensor
Professional Installation Required
Caution
Prior to installing or using the MSM415, consult with a professional installer trained in RF
installation and knowledgeable in local regulations including building and wiring codes, safety,
channel, power, indoor/outdoor restrictions, and license requirements for the intended country. It
is the responsibility of the end user to ensure that installation and use comply with local safety
and radio regulations.
Cabling: You must use the appropriate cables, and where applicable, surge protection, for your
given region. For compliance with EN55022 Class-B emissions requirements use shielded Ethernet
cables. Cables with large boots may not insert into the RJ-45 connectors properly. It is recommended
that you do not use such cables.
Plenum installation: The MSM415 and appropriate cabling can be installed in a plenum (UL2043
rating). The MSM415 should be installed with its top surface facing the floor (similar orientation as
in a ceiling installation). However, it is left to a qualified installer to determine how to install/secure
the MSM415 in a plenum in an appropriate and safe manner. Plenum-rated cables and attachment
hardware must be used.
Safety: Take note of the following safety information during installation.
„
If your network covers an area served by more than one power distribution system, be sure all
safety grounds are securely interconnected.
Ethernet
Radio
Slow Blink
Any
Any
Solid Green
Any
Any
Off
Off
Description
The Sensor is unable to connect to the RF Manager Server.
There is an error on 802.11a/b/g interfaces.
The Sensor is experiencing a software error.
The Sensor is not powered on or it is in the process of starting
up.
Hardware Installation
Installing RF Security Sensors
1-11
Advertisement
Table of Contents
