Connect The Sensor To The Network - HP MSM415 Hardware Installation

3. Once the Java ™ Plug-in Control Panel dialog is open, go to the Browser tab and
select the checkbox Microsoft Internet Explorer.
4. On the End User License Agreement (EULA) screen, read the agreement carefully
and select I have read and agree to the Licensing Agreement above. Click Next.
5. If you see the Welcome screen, close the window. You are done with the Server setup. You
can revisit the Welcome screen later.

Connect the Sensor to the Network

Ensure that the Server is already running on your network. Add the DNS entry wifi-security­
server on all DNS Servers. This entry should point to the IP address of the Server.
To connect the MSM415 Sensor to the network, complete the following:
1. Ensure that DHCP is running on the subnet to which the Sensor will be connected.
2. Connect one end of the Network Interface cable to the Ethernet port (port 1) on the
Sensor.
3. Connect the other end of the Network Interface cable to an Ethernet jack that is
connected to the desired subnet.
Important If DHCP is not enabled on a subnet, Sensors cannot connect to that subnet with zero
configuration. See
4. Wait for two minutes.
5. Check the Status LEDs on the Sensor. If all LEDs glow green, then the Sensor is
operational and connected to the Server.
"Manually Configuring the Sensor (Optional)" on page 2-6
Getting Started
Connect the Sensor to the Network
.
2-5