Motorola APX 7000 Basic Service Manual page 236

Sec 2: 8-16
RF Board Assembly (32)
8.7.7 Removal of the VOCON Board Assembly (G)
NOTE: Reconfirm the Flex connector between the Control Top Assembly (J) and the
1. Gently rotate the VOCON Board Assembly just enough to clear the Main Chassis and Option
Board connector. Slide out the VOCON Board Assembly as shown in
8.7.8 Removal of the Knobs
A. Remove the Frequency Knob
To remove the Frequency Knob (13):
1. Hold the radio in one hand so that the top of the radio faces upward, and the front of the radio
faces you.
Connector
Small Coax Cable
Figure 8-22. Remove RF Board Assembly
VOCON Board Assembly (G) or, if so equipped, the Option Board is disconnected
(see step 2 on page 2:8-30). Failure to do so may damage the connectors or the
flex.
VOCON Board Assembly (G)
Figure 8-23. Remove VOCON Board Assembly
Disassembly/Reassembly Procedures: Radio Disassembly
Figure 8-23.