Motorola APX 7000 Basic Service Manual page 52

Sec 1: 5-4
Name of Display
FLASHcode
RF band 1
RF band 2
Tuning ver
Proc ver
Option Board Type
Option Board
Bluetooth Addr
Option Board SW
Version
NOTE: All displays are temporary and will expire without any user intervention. If
NOTE: Press the Top side (purple) button to advance the test environments from "RF
3. Do one of the following:
• Press the Top Side Button to stop the displays and toggle between RF test mode and the
Control Top and Keypad test mode. The test mode menu "CH TEST" is displayed,
indicating that you have selected the Control Top and Keypad test mode. Go to Section
"5.2.3 Control Top and Keypad Test Mode" on page
NOTE: Each press of the Top Side Button will toggle between "CH TEST" and "RF TEST".
• Press the Top Button (Orange button) to stop the displays and put the radio into the RF
test mode. The test mode menu, "1 CSQ", is displayed, indicating test frequency 1, Carrier
SQuelch mode. Go to Section
NOTE: Once your radio is in a particular test mode, you must turn off the radio and turn it
Performance Checks: Display Radio Test Mode (Dual-Display Version)
Table 5-2. Test-Mode Displays (Continued)
The FLASH codes as programmed in the
codeplug
The radio's operating frequency
The radio's operating frequency
Version of Tuning codeplug
Version of Processor
Type of Option Board in the radio
Address of the Bluetooth IC
Version of Option Board software
information is longer than the physical length of the radio's display, the information
will wrap around to the next display. After the last display, "RF TEST" is displayed.
To freeze any of the displays, press the left arrow on the 4-Way Navigation Button.
To resume automatic scrolling, press the right arrow on the 4-Way Navigation
Button. To rapidly scroll forward through the displays, continue pressing the right
arrow. You cannot scroll backwards.
TEST", "CH TEST", "RGB TEST", "CID TEST" then press the orange button to
confirm selection. Press any other buttons to advance the test.
Once a test is carried out, restart the radio to proceed to another test.
back on again to access the other test mode.
Description
1:5-6.
"5.2.2 RF Test Mode" below.
Appears
Always
Always
When the radio has more than 1
operating frequency
Always
Always
When the radio is equipped with
an Option Board
When the radio is equipped with
a Bluetooth Option Board
When the radio is equipped with
an Option Board