Installing Expansion Blades In The 19" Chassis (Optional) - NEC Univerge SV9100 Hardware Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

UNIVERGE SV9100

System Hardware Manual

Figure 3-3 19" Controlling Chassis – Guides Slot 1

Slide the GCD-CP10 blade into the chassis until resistance (back

plane) is felt.

Figure 3-4 Installing the GCD-CP10 Blade

Gently push until the blade seats. Tighten the two retaining screws on

front of the blade.

Figure 3-5 GCD-CP10 Blade Installed

Installing Expansion Blades in the 19" Chassis (Optional)

When adding additional chassis to the system to expand the capacity, a

GPZ-BS10 must be installed in the Controlling Chassis and a GPZ-BS11

must be installed in all Expansion Chassis. This connection is required with

any multiple-chassis setup.

Show Quick Links

Table of Contents