AVENAR detector 4000
Selectable installation locations in
the programming software
(FSP‑5000‑RPS)
Production location
Garage
High storage warehouse without
vehicle traffic with combustion
engine
Conference hall/waiting room/
fairground
Kitchen/casino/restaurant during
active operation
Warehouse with vehicle traffic
Rate of rise only (optical sensor off)
Optical only (thermal sensor off)***
Fixed temperature heat only (optical
sensor off)
Optical/chemical (thermal sensor
off)***
Schools/kindergarten
Theater/concert hall
O = optical sensor
T
= thermal maximum unit
max
T
= thermal differential unit
diff
C = chemical sensor
* If optical sensor sensitivity is low, the detector will only trigger if smoke as well as an
increase in CO concentration or temperature is detected.
*** For FAP-425-DOTC-R: does not comply with EN54-7
For details on installation height, see FAH‑425‑T‑R, page 17
4.2
FAP‑425‑DOT‑R / FAP‑425‑OT‑R / FAP‑425‑OT
Notice!
The default setting of the FAP-425-DOT-R, FAP-425-OT-R and FAP-425-OT detector types in
RPS is "Office (day mode)". For a description of this setting, see the below table.
Bosch Sicherheitssysteme GmbH
Detector Type
Sensitivity
Thermom
ax (T
max
O, T
, T
, C
Low (B)
max
diff
O, T
, T
, C
High (A2)
max
diff
O, T
, T
, C
Low (B)
max
diff
O, T
, T
, C
High (A2)
max
diff
O, T
, C
Low (B)
max
O, T
, T
, C
Low (B)
max
diff
T
, T
High (A2)
max
diff
O
-
T
High (A2)
max
O, C
-
O, T
, T
, C
High (A2)
max
diff
O, T
, T
, C
High (A2)
max
diff
Operation Guide
Optical
Chemical
)
(O)
(C)
Low*
Medium
Low*
Low
High
High
Low*
Medium
Low*
Low
Low*
Low
-
-
Low
-
-
-
Low
High
Medium
High
Medium
High
Programming | en
15
2014.11 | 1.1 | F.01U.283.550