Warranty; Repair; Disposal - Bosch AVENAR FAP-425 Operation Manual

34 en | Maintenance and Service
Error code
10000000
11000000
10100000
10011110
0000xxxx
–
The optical initial set-up value of a new detector is stored in the integrated EEPROM during
the final inspection. The contamination value specifies by how much this analog value has
increased in comparison with the delivery state.
7.4

Warranty

Defective detectors are exchanged free of charge in the case of a claim under the warranty.
7.5

Repair

In the event of a defect, exchange the entire detector.
7.6

Disposal

Unusable electrical and electronic devices or modules must not be disposed
of with normal household refuse. They must be disposed of in compliance
with the applicable regulations and directives (e.g. WEEE in Europe).
Packaging film for the FAP-425-DOTC-R
The packaging bag used for multisensor detectors with C sensor consists of tear-resistant PE-
ALU laminated film and may be disposed of with the household refuse.
Defective detectors are exchanged and should be disposed of in accordance with legal
regulations.
2014.11 | 1.1 | F.01U.283.550
Contamination
Cause of trouble and troubleshooting
General C malfunction
Possible causes:
– – Thermal sensor fault
– – Maximum operation duration (5 years)
of the C sensor has been exceeded.
T and C sensors are switched off; the optical
sensor is still in operation.
Exchange detector immediately.
The impedance of the electrochemical cell is
too high.
The C sensor is switched off; the rest of the
sensors are still in operation.
Exchange detector immediately.
The permissible operating temperature
(-10 °C to +50 °C) has been exceeded. The C
sensor is switched off; the rest of the sensors
are still in operation.
Malfunction due to read/write error in the
EEPROM
Detector is switched off and must be
exchanged immediately.
Number of read/write errors in the EEPROM
Operation Guide
AVENAR detector 4000
Bosch Sicherheitssysteme GmbH