Mounting The Ap-7131; Wall Mounting - Motorola AP-7131 Installation Manual

1. Connect the Power Injector to an AC outlet (110VAC to 220VAC).
2. Connect an RJ-45 Ethernet cable between the network data supply (host) and the Power
Injector Data In connector.
3. Connect an RJ-45 Ethernet cable between the Power Injector Data & Power Out connector
and the AP-7131 GE1/POE port.
NOTE
Ensure the cable length from the Ethernet source (host) to the Power Injector and AP-7131
does not exceed 100 meters (333 ft).
The Power Injector has no On/Off power switch. The Injector receives power and is ready
for device connection and operation as soon as AC power is applied. Refer to the Installation
Guide shipped with the Power Injector for a description of the device's LEDs.

2.4 Mounting the AP-7131

The AP-7131 can attach to a wall, mount under a suspended T-Bar or above a ceiling (plenum or
attic). Choose one of the following mounting options based on the physical environment of the
coverage area. Do not mount the AP-7131 in a location that has not been approved in a site survey.

2.4.1 Wall Mounting

Wall mounting requires hanging the AP-7131 along its width (or length) using the pair of slots on the
bottom of the unit and using the AP-7131 mounting template (on the next page) for the screws.
CAUTION
The hardware and tools (customer provided) required to install the AP-7131 on a wall consists of:
• Two Phillips pan head self-tapping screws
(ANSI Standard) #6-18 X 0.875in. Type A or AB Self-Tapping screw, or
(ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D Self-Tapping screw
• Two wall anchors
• Wall mount template (included on the next page)
• Security cable (optional)
Cabling the Power Injector to the AP-7131's WAN port renders the
AP-7131 non-operational. Only use a AP-PSBIAS-1P3-AFR model Power
Injector with the AP-7131's GE1/POE (LAN) port.
An AP-7131 should be wall mounted to concrete or plaster-wall-board
(dry wall) only. Do not wall mount an AP-7131 to combustible
surfaces.
Hardware Installation 9