Fujitsu Pcna Ep Oce14102 Accessories; Applying Power; Viewing The Leds - Fujitsu PCNA EP OCe14102 Installation Manual

2. Hardware Installation

Fujitsu PCNA EP OCe14102 Accessories

Table 2-2 provides model number, name, interface and required quantities if you want
to order additional or replacement transceivers, or cables.
Table 2-2 Emulex OneConnect Accessories
Model Number
PCNA SFP+ MMF
OCE14102

Applying Power

To apply power:
1. Verify that the adapter is securely installed in the computer.
2. Verify that the correct device is attached.
3. Plug in and turn on the computer.
4. Observe the boot banner for Power On Self Test (POST) results.

Viewing the LEDs

Each port connector has two LEDs: an amber LED and a green LED.
Amber LED (Link)
On (constantly) = Link up

Off = Link down

Green LED (Ethernet Activity)
Blink = Activity on the Ethernet link

Off = No activity on the Ethernet link

PCNA EP OCe14102 2x 10Gb
Model Name
SFP+ 10 Gigabit Ethernet
10GBASE-SR/SW Transceive
Applying Power
Quantity Interface
1 pc 10Gbase-SR Optical
Page 13