JVC KM-H3000 User Manual page 20

7. Press the Confrm knob to commit the load.
Press the Cancel knob to cancel the load.
Power-Save Mode
The switcher goes into a Power-Save mode after a
certain amount of time (20 minutes by default) without
user interaction. Touching any control will wake the
switcher. Any functionality associated with the
touched control is ignored until the unit is active and
all lights and display are turned on.
During Power-Save mode, video related hardware is
not affected and video signals are still passed through
the switcher.
To configure the power-save timeout:
1
2
1. Press MENU.
2. Press the PERS Wipe Pattern button.
3. Press the right knob to set the switcher
power-save behavior. You can choose from the
following:
• PwrSve — All buttons and the menu display
turn off. The switcher conserves as much
power as possible without affecting on-air
video.
• Sleep — The menu display turns off. Buttons
light and slowly fade in a raindrop pattern.
4. Use the right knob to set the power-save timeout
(in minutes). You can select a value from 0 (off)
to 999 minutes.
Transition Rate Units
You can select the units used to specify durations for
various switcher transitions. Choose the units that
you are most comfortable working with.
To select the units for switcher transitions:
1
2
16
3
3
1. Press MENU.
2. Press the PERS Wipe Pattern button.
3. Use the Rate knob to select the units used to
specify switcher transition rates. You can choose
from the following:
• Frames — Switcher transitions are specified
in frames.
• Secnds — Switcher transitions are specified
in seconds.
Double-Press Rate
You can set the double-press rate of the switcher to
suit your preference. Setting a fast rate requires you
to double-press the knobs in quick succession in
order to be recognized as a double press. Setting a
slow rate allows more time between presses but may
register two single presses as a double press. Find a
value that is most comfortable for your operating
style.
To set the switcher double press rate:
1
2
1. Press MENU.
2. Press the PERS Wipe Pattern button.
3. Press the DblPrs Speed knob.
4. Double-press the middle knob at a rate you feel
comfortable. This defines the double press rate.
5. Press MENU to save the setting.
Resource Sharing
The switcher can use one Chroma Key and two
channels of DVE simultaneously. You can specify
how the Chroma Key is shared between keys and the
DVE resources are shared between keys and the
transition area on your switcher.
3 4