Radio Tuning Setup - Motorola CP185 Basic Service Manual

5-2
3. Radio functionality inherent in one radio cannot be cloned to another radio that does not contain
the same functionality. Tuning and alignment information are not transferable and are not
affected by cloning.
Procedure:
1. Turn source and destination radios off.
2. Connect cloning cable (PMDN4076_R) to programming port of the two radios.
3. Turn on the destination radio.
4. Press and hold
icon are displayed on the source radio and at the same time LED of the radio turns solid amber.
5. "SLAVE" and programming mode icon are displayed on the destination radio and at the same
time LED of the radio turns solid amber.
6. During the cloning process, LED flashes in amber and source radio displays "CLONING" while
destination radio displays "PROG ON".
7. When cloning is completed, the source and destination radios display "COMPLETE". To exit
cloning mode, radios should be turn off.
8. Turn both radios off.
9. Disconnect the cloning cable from both radios and turn them on for normal operation.
5.4

Radio Tuning Setup

A Windows 2000/XP/Vista PC (personal computer) and Entry Level Radio Tuner are required to tune
the radio. To perform the tuning procedures, the radio must be connected to the PC, Test box and
Universal Test Set as shown in . Refer to online help files for the tuning procedures.
on the source radio and power up. "MASTER" and programming mode
Radio Programming and Tuning: Radio Tuning Setup