Figure 6-16. Main Circuit Board, O-Ring And Battery Contact Seal Reassembly; Figure 6-17. Sub Circuit Board And Accessory Bracket Reassembly - Motorola CP185 Basic Service Manual

Maintenance – CP185: Disassembling and Reassembling the Radio – General
5. Tighten the RF Support Screw (17) with a flat head screw torque to 1.91 Ib-in – 2.17 Ib-in.
(Refer Table 6-1 on page 6-14 for torque in other units).
B

Figure 6-16. Main Circuit Board, O-ring and Battery Contact Seal Reassembly

6. Insert the Sub Circuit Board Flexible Cable (12) into the respective connectors at the top of the
main circuit board.
7. Push the latches into the connectors.
8. Place the sub circuit board straight down on top of the chassis.
9. Tighten the screw that is holding the sub circuit with a Phillips screwdriver torque to
1.91 Ib-in – 2.17 Ib-in. (Refer Table 6-1 on page 6-14 for torque in other units).
10. Tighten the two nuts on the On/Off Volume Knob and Channel Knob Shafts with the Crab Eye Nut
Opener.
11. Align and Insert the Accessory Bracket (31) into the audio jack hole. (Refer Figure 6-17).

Figure 6-17. Sub Circuit Board and Accessory Bracket Reassembly

C
Accessory Brackets
Audio Jack
6-13
A