Remote Control - Sharp HT-SB30D Operation Manual

Remote control

■ Battery installation
DO NOT INGEST BATTERY,
CHEMICAL BURN HAZARD
The remote control supplied with this
●
product contains a coin/button cell
battery. If the coin/button cell battery is
swallowed, it can cause severe internal
burns in just two (2) hours and can lead
to death.
Keep new and used batteries away from
●
children. If the battery compartment
does not close securely, stop using the
product and keep it away from children.
If you think batteries might have been
●
swallowed or placed inside any part
of the body, seek immediate medical
attention.
This product contains a CR Coin Lithium Battery
which contains Perchlorate Material – special
handling may apply.
California residents, see
www.dtsc.ca.gov/hazardouswaste/perchlorate/
1
While pushing the locking tab towards the
center of the remote control, slide out the
battery holder.
Locking
2
Remove the old battery from the battery hold-
er, insert the new battery and then slide the
battery holder back into the remote control.
Battery holder
Polarity
(+) symbol
Battery type
Locking tab
WARNING
Back of
remote control
tab
Positive (+)
side up
Precautions for battery use:
Remove the battery if the sound bar will not be
used for a long period of time. This will prevent
potential damage due to battery leakage.
Caution:
Do not use rechargeable battery (nickel-cad-
●
mium battery, etc.).
Danger of explosion if battery is incorrectly
●
replaced.
Replace only with the same or equivalent
●
type.
Batteries (battery pack or batteries installed)
●
shall not be exposed to excessive heat such
as sunshine, fire or the like.
Installing the battery incorrectly may cause
●
the sound bar to malfunction.
Notes concerning use:
Replace the battery if the operating distance
●
is reduced or if the operation becomes errat-
ic. Purchase "CR 2025", coin lithium battery.
Periodically clean the transmitter on the re-
●
mote control and the sensor on the sound
bar with a soft cloth.
Exposing the sensor on the sound bar to
●
strong light may interfere with operation.
Change the lighting or the direction of the
sound bar if this occurs.
Keep the remote control away from mois-
●
ture, heat, shock, and vibrations.
■ Test of the remote control
The remote control can be used within the range
shown below:
Remote sensor
8" - 20'
(0.2 m - 6 m)
E-12
SOUND BAR HOME THEATER SYSTEM HT-SB30D
ON/
MUTE STAND-BY
SOUND MODE
CINEMA MUSIC NEWS
BYPASS
SURROUND INPUT
TV
VOL CH
VOL
RRMCGA322AWSA