Setting The Projector Id - Epson PowerLite 1720 Installation Handbook

Epson PowerLite 1720 / 1730W
Operating Two or More Projectors with
the Remote Control
If you're using more than one projector, you can control all the
projectors—or just selected ones—by using the projector and remote
control ID system. First assign a unique ID number to each projector.
Then set the remote control to match the ID of the projector you
want to operate. This lets you control it without affecting the others.

Setting the Projector ID

The projector's default ID is set to Off. This lets it respond to
commands from any remote control. To change the ID, follow these
steps:
1. Press the
projector's menu screen.
2. Select
3. Use the
Enter
4. When done, press
Checking the Projector ID
To check the ID of a specific projector:
1. Point the remote control at the projector you want to check.
button on the remote control. You see the
Menu
Extended > Projector ID
pointer button to highlight the new ID, and press
to select it.
to exit the menu system.
Menu
INSTALLATION HANDBOOK
.
Remote Control Information
10