Setting The Remote Control Id - Epson PowerLite 1720 Installation Handbook

Epson PowerLite 1720 / 1730W
note
If you're using a remote
control ID other than the
default ID of zero, you have
to set the ID each time you
turn on the projector.
2. Press the button on the remote control. You see a message on
ID
the screen, showing the projector's ID:
If the message says the remote control is "On," then you can use
the remote control to operate that projector. If it says "Off," then
you have to change the ID of the remote control before operation
is possible, as described in the next section.

Setting the Remote Control ID

The remote control's default ID is zero. This lets it operate any
projector. To set it to operate only those projectors with a specific ID,
follow these steps:
1. Press and hold the
2. While holding the
remote control (1 through 9) that corresponds to the ID of the
projector(s) you want to operate. Selecting zero lets you control all
projectors.
INSTALLATION HANDBOOK
button on the remote control.
ID
button, press the numbered button on the
ID
Remote Control Information
11