NEC Express5800/320Fd-MR N8800-123F, EXP320K User Manual page 412

insert the EXPRESSBUILDER DVD into the DVD-ROM drive. Master control
menu appears by the Autorun function.
Click [Software Setup] - [DianaScope]. Run the JRE installer in the
DianaScope installation menu.
# If you would like to install the latest Java Runtime, go to the following
website to download:
http://java.sun.com/j2se/
Do you connect LAN cable appropriately?
→
Check if IP address is duplicated?
→
Did you set ESMPRO/ServerAgent to monitor the server?
→
Is network connection restricted by the firewall or thegateway?
→
Server console screen does not appear on the web Remote KVM console screen:
Did you set the server's screen resolution properly?
→
Management function, set the screen resolution 1024 x 768 and the refresh rate
should be less than 75Hz.
Forgot login name/password for the Remote Management Function on the web
browser:
→
position, the BMC configuration including the password returns to the factory
Check if LAN cable is connected appropriately. The server sensors work
properly only when the cable is connected properly. Make sure the cable isn't
mistakenly connected to the server's LAN connector or to the serial port
connector.
IP address for the management LAN port is configured as 192.168.1.1 at the
factory default setting. Change the IP address if this one is already used on the
network, as this one isn't recognized appropriately.
Change the ESMPRO setting. Start ESMPRO/ServerAgent in the Windows
control panel, then go to [Express5800 Server] - [Monitor] from [System] tab,
then click the check box. ([Unmonitored] is selected by default) After
changing the setting, the server monitoring starts automatically. You do not
have to reboot the server, but you need to restructure the tree if you still
cannot monitor the server.
Network connection may be restricted by a firewall setting. See if you can
solve the problem by connecting the server and a client PC directly with a
cross cable. Refer to Chapter 4 [Remote Management Function] - [BMC
Configuration] - [Network Configuration], then check the port of the Remote
Management Card and set the firewall or the gateway.
When you display the server screen by using the remote KVM in the Remote
Refer to Chapter 4 on BMC configuration jumper. By changing the jumper
Troubleshooting 7-21