Table of Contents
Advertisement
VisuaLink 128/384 Quick Installation Guide
Chapter 3 Startup Screen for the VisuaLink 128 and VisuaLink 384
3.1 Start up
configuration
screens
Thank you for purchasing one of the most
simple and portable video conferencing systems
available.
We will now show you how to set up your system.
This will only have to be done once.
NOTE: If remote controller doesn't work, make
NDA-24232 Issue 2.0
When you first turn on your VisuaLink, there will be an initial configuration
screen. These configuration screens will have to be completed before your system
becomes operational.
The following are the startup screens that will be active on first power up or acti-
vated on demand by the user after choosing the Environmental initialize.
Welcome Screen:
This is a welcome screen for the User.
VisuaLink
sure the switch setting of D30 camera IR
out is ON. Switch is located on the
bottom of the camera.
Click here to continue
Configure later
Chapter 3
Note is yellow
Page 3-1
Advertisement
Table of Contents
