Table of Contents
Advertisement
Chapter 6
6.6 Hardware
Installation
Page 6-6
This procedure provides instruction on how to connect a VL128/384 to a
Computer.
1. Locate unpack and install Video Capture Card
Please follow Manufactures Installation procedure for Video Capture
Card.
2. Locate and unpack VL128/384, Power Supply Transformer, Power Cord
Audio/Video Cable (RCA to RCA) and Wireless Remote Control
3. Place the VL128/384 next to the PC. The VL128/384 must not be installed on
its side. It must lay flat.
4. Take the VL128/384 Power Cord and insert two-prong plug into WALL
OUTLET and the other end into the VL POWER SUPPLY
TRANSFORMER.
5. Take the Power Supply Transformer and plug into DC IN 5V port on the back
of VL128/384.
6. On the backside of the VL128/384 locate the connector labeled VIDEO OUT1
and AUDIO OUT. See
7. Using the Audio/Video cable which was included with the VL128/384 system,
plug the yellow (RCA) connector into the VIDEO OUT1 and plug the white
(RCA) connector into the AUDIO OUT. See
8. On the PC side, locate other end of the audio/video cable and connect the
yellow jack into VIDEO IN of the Video capture card. Then connect the white
jack into the LINE IN of your Sound Card, this connection may require the
addition of a RCA to 3.5 mm mini phono adapter (included).
9. If using external speakers, be sure to connect to the SPEAKER OUT of your
sound card or line out of your sound card if using amplified speakers). If the
workstation does not have a sound card, connect the speakers directly into the
VL128/384.
10. Locate and unpack the Audio Technica AT841/INT Microphone. Insert the 3.5
mm mini phono plug into the VL MICROPHONE INPUT 1 (MIC1) which
is located on the back of the VL128/384.
11. Locate and unpack the PC Camera IK-M28, power Transformer and the single
RCA to RCA video cable.
12. Place the PC Camera next to or on top of the PC, plug the power transformer
into the WALL OUTLET and the other end into DC IN 6V port on the back
of the camera.
13. On the Camera side, insert one end of the video cable into the VIDEO OUT
port of the camera.
14. On the VL128/384 side insert the other end of the video cable into the VIDEO-
IN port of the VL128/384.
15. Press the POWER SWITCH on the front of the VL128/384 to turn on.
16. If BRI Network terminates through the PBX, proceed to
Network terminates directly to the workstation proceed to
17. Locate and unpack NT-1, Power Transformer and Network Cable.
VisuaLink Quick Installation Guide
Figure 6-3
and
Figure
6-4.
Figure 6-3
and
Figure
6-4.
Step
24. If the BRI
Step
18.
NDA-24232 Issue 2.0
Advertisement
Table of Contents
