Table of Contents
Advertisement
Chapter 5
Page 5-2
4. Using a Phillips screwdriver, remove the four (4) screws that attach the cover
panel to the housing of the VL 128. The four screws are located on the bottom
of the VL 128.
Note: While in this position, place the Upgrade Label supplied with the
Upgrade Kit at the position shown in the illustration below. The label
shows the VisuaLink 128 has been upgraded to a VisuaLink 384. Do not
block the air grid when placing label.
Screws
5. Using a Phillips screwdriver, remove the three (3) screws that attach the cover
panel to the housing of the VL 128. The four screws are located on the rear of
the VL 128.
6. Slid the cover towards the rear of the chassis, to remove. Using a Phillips
screwdriver remove the four (4) screws from the rear panel.
VisuaLink 128/384 Quick Installation Guide
Upgrade Label
Upgrade
Lable
Screws
Screws
Screw
Screws
NDA-24232 Issue 2.0
Advertisement
Table of Contents
