Table of Contents
Advertisement
VisuaLink 128/384 Quick Installation Guide
2.2 Connection
Procedure
NDA-24232 Issue 2.0
Procedure for connecting a stand-alone VisuaLink. See
layout of the VisuaLink 128. See
VisuaLink 384.
1. Connecting the Video Out of the VisuaLink to the TV Monitor
Using the attached video cable, that comes with the VL, plug one side into the
TV Monitor connection marked VIDEO 1 INPUT. Plug the other end into
the connection marked VIDEO OUT 1 on the VisuaLink.
2.
Connecting audio from the VisuaLink to the TV Monitor. (optional)
Using the provided audio cable, that comes with the VL, plug one end into the
AUDIO INPUT 1 of the TV Monitor. Plug the other end into the AUDIO
OUTPUT of the VisuaLink.
Note: If a VoicePoint is used do not connect the audio output connection.
. Connecting the Voicepoint to the VisuaLink. (optional)
3
Using the attached RJ11 cable of the VoicePoint, plug the open end into the
VisuaLink connection labeled TEL.
4. Connecting the NT1 device to the VisuaLink. (optional)
Using the provided data cable (RJ45 - RJ45), plug one end into the VisuaLink
connection labeled ST/LINE. The other end of the cable, plugs into the NT1
device. Repeat procedures if connecting a VisuaLink 384 and three NT1s.
Note: If the NT1 device is located more than 300 ft. (91 m.) away. Set the
VL128 TERM SWITCH located on the back of the unit to the ON
position. Set the VL384 STRIP SETTING inside the unit to the ON
position.
5. Connecting a microphone to the VisuaLink. (optional)
Plug the 3 1/2 mini connector into the VisuaLink connection marked MIC1.
6. Connecting the Video Camera to the VisuaLink. (optional)
Using the provided video cable, plug one end into the connection marked
VIDEO OUT on the D30 camera. Plug the other end of the video cable into
the VisuaLink connection labeled VIDEO IN 1.
7. Connecting the camera control to the VisuaLink. (optional)
With a 8 pin minidin to 8 pin minidin, plug one end into the D30 camera
connection marked VISC IN. Plug the other end into the VisuaLink
connection marked SERIAL 1.
8. Connecting the camera power. (optional)
Plug the Camera AC Power to the AC Power Strip at the bottom of the
cabinet.
Appendix A
Appendix B
for the system layout for the
Chapter 2
for system
Page 2-3
Advertisement
Table of Contents
