Mounting the switch on a workbench or floor
You can install the switch on a clean, sturdy workbench or on the floor.
Installation preparation
Before you mount the switch on a workbench or on the floor:
Position the installation holes and drill holes. Make sure the holes are exact in diameter and depth
•
for the anchors to operate correctly.
Remove the shank and plug from a wall anchor, insert the spade-shaped wedges into the grooves
•
on the shank, put them into an installation hole, and hammer the shank into the ground. See
13.
IMPORTANT:
Before you hammer the shank to the workbench or floor, insert the spade-shaped wedges into the
grooves on the shank. Otherwise, the wall anchor cannot be installed correctly.
Figure 13 Installing the shank to the plug
1
2
3
4
(1) Shank
(3) Plug
Installation procedures
CAUTION:
Do not use the fan tray handles, power supply handles, chassis air vents, or handle of chassis back cover
for moving the chassis. These parts are not designed for weight support. Any attempt to carry the chassis
with these parts might cause equipment damage or even bodily injury.
This task requires a minimum of two people. HP recommends that you use a mechanical lift to move the
chassis.
To mount the switch on a workbench or floor:
(2) Groove
(4) Spade-shaped wedge
17
Figure