Installing Frus; Attaching An Esd Wrist Strap - HP 10504 Installation Manual

Installing FRUs

There is no required order for installing FRUs. HP recommends that you connect power cords after
installing all required FRUs.
TIP:
Keep the chassis and component packages for future use.

Attaching an ESD wrist strap

The switch provides an ESD wrist strap. To minimize ESD damage to electronic components, wear the
ESD wrist strap and make sure it is reliably grounded when installing modules.
To use an ESD wrist strap:
1. Make sure the switch is reliably grounded. For how to ground your switch, see
switch."
2. Put on the wrist strap.
3. Tighten the wrist strap to keep good skin contact. Make sure the resistance reading between your
body and the ground is between 1 and 10 megohms.
4. As shown in
attach it to the grounding screw of the chassis with an alligator clip.
Figure 18, insert the ESD wrist strap into the ESD socket on the switch chassis, or
21
"Installing the