Other Programming; Registering A Unit - Panasonic KX-TG9581 Operating Instructions Manual

Programming
Setting the first ring for the call block list
Handset / Base unit
If you do not want the first ring from a number on
the call block list to sound, turn the first ring setting
to "Off". The default setting is "On".
1
MMENUN#173
2
MbN: Select the desired setting. a MSAVEN
3
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Viewing/editing/erasing call block numbers
Handset
1
MMENUN#217
2
MbN: Select the desired entry.
R To exit, press MOFFN.
3
To edit a number:
MEDITN a Edit the phone number. a
MSAVEN a MOFFN
To erase a number:
MERASEN a MbN: "Yes" a MSELECTN a
MOFFN
Base unit
1
MMENUN#217
2
MbN: Select the desired entry.
R To exit, press MEXITN.
3
To edit a number:
MEDITN a Edit the phone number. a
MSAVEN a MEXITN
To erase a number:
MERASEN a MbN: "Yes" a MSELECTN a
MEXITN
Note for handset and base unit:
R When viewing, "Block w/o num."
*2
is displayed if the blocking
w/o number"
incoming calls without phone number feature is
turned on. To turn the feature off: MERASEN a
MCN a MSAVEN a MOFFN (Handset) or MEXITN
(Base unit)
*1 Handset
*2 Base unit
52
TG958x_0704_ver031.pdf 52
*1
/"Block
For assistance, please visit http://www.panasonic.com/help

Other programming

Changing the handset name
Each handset can be given a customized name
("Bob", "Kitchen", etc.). This is useful when you
make intercom calls between handsets. You can
also select whether or not the handset name is
displayed in standby mode. The default setting is
"No". If you select "Yes" without entering any
handset name, "Handset 1" to "Handset 12"
is displayed.
Handset
1
MMENUN#104
2
Enter the desired name (max. 10 characters).
3
MSAVEN
4
MbN: Select the desired setting. a MSELECTN
2 times a MOFFN

Registering a unit

Operating additional units
Additional handsets
Up to 12 handsets can be registered to the base
unit.
Important:
R See page 4 for information on the available
model.
Registering a handset to the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset is
not registered to the base unit, re-register the
handset.
1
Handset:
MMENUN#130
2
Base unit:
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing, press
MLOCATORN again to stop, then repeat this
step.
2014/07/04 10:32:27