Panasonic KX-TG9581 Operating Instructions Manual page 62

Answering System for Landline
Important:
R Make sure the unit's date and time setting is
correct (page 17).
R Record the greeting message beforehand
(page 62).
1
For line 1: MMENUN#3421
For line 2: MMENUN#3422
2
MbN: Select the desired greeting setting. a
MSELECTN
"Greeting1" or
"Greeting2"
"Greeting1&2" or
"Greeting1&Only"
"Greeting only"
3
Enter the desired hour and minute you wish to
start "Greeting1".
4
Proceed with the operation for your unit.
Handset: *: Select "AM" or "PM". a MOKN
Base unit: MAM/PMN: Select "AM" or "PM".
a MOKN
5
Enter the desired hour and minute you wish to
start "Greeting2" or "Greeting only".
6
Proceed with the operation for your unit.
Handset: *: Select "AM" or "PM". a MSAVEN
Base unit: MAM/PMN: Select "AM" or "PM".
a MSAVEN
7
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Selecting "Greeting only" or
"Greeting1&Only"
You can select "Greeting only" or
*1
"Greeting1&Only"
announce a greeting message to callers but not
record messages.
Select "Greeting only" or
"Greeting1&Only" in step 2 on "Selecting the
greeting message", page 61.
*1 During the time when greeting only is set.
62
TG958x_0704_ver031.pdf 62
Go to step 7.
Go to step 3.
MbN: "Yes" a
MOKN a Go to
step 7.
which sets the unit to
For assistance, please visit http://www.panasonic.com/help
Recording your greeting message
Handset / Base unit
1
For line 1: MMENUN#3021
For line 2: MMENUN#3022
2
MbN: Select the desired greeting message. a
MSELECTN
3
MbN: "Yes" a MSELECTN
4
After a beep sounds, speak clearly about
20 cm (8 inches) away from the microphone (2
minutes max.).
5
Press MSTOPN to stop recording.
6
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Using a pre-recorded greeting
message
The unit provides 2 pre-recorded greeting
messages:
– If you reset to pre-recorded greeting or do not
record your own greeting message, the unit
plays a pre-recorded greeting asking callers to
leave a message.
– If the greeting setting (page 61) is set to
"Greeting only" or "Greeting1&Only",
callers' messages are not recorded and the unit
plays a different pre-recorded greeting message
asking callers to call again.
Resetting to a pre-recorded greeting message
If you want to use a pre-recorded greeting
message once you record your own greeting
message, your own recorded greeting message is
erased.
Handset / Base unit
1
For line 1: MMENUN#3041
For line 2: MMENUN#3042
2
MbN: Select the desired greeting message. a
MSELECTN
3
MYESN
4
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
2014/07/04 10:32:28