Adjusting The Paper Cassette For The Paper Width - Panasonic UF-580 Service Manual

8.7.

Adjusting the Paper Cassette for the Paper Width

How to Adjust the Paper Cassette for the Paper Width
The factory default Paper Width setting for the Paper Cassette is on Letter/Leagal size for USA and Canada,
A4 size for other destinations. To change the paper width to other size, follow the steps below.
1
Paper Separation Clip
2
Paper
Width Guide
Max. Paper
Capacity Mark
3
NOTE
1. If you forge t to change th e Recordin g Paper Si ze setti ng in Fax Parameter No. 23
when di ffere nt paper i s ins talled i n the cassette, the unit will Stop printin g after the
1st page of an Inc oming Fax and dis play a " PAPER SIZE MISMATCH" error.
Then, the Recordi ng Paper Size settin g autom ati cal ly adjusts to th e prop er si ze and the
unit resumes pri nti ng the Incoming Fax fro m the 1s t page.
1. Release the left Paper Separation Clip
latch.
2. Pull up the Paper Separation Clip to
remove it.
3. Reposition the Paper Separation Clip
into the A (A4) or L (Letter/Legal) slot.
4. Swing the Paper Separation Clip
downward to latch it in place.
1. Load the paper into the Paper Cassette.
Slide the paper width guide to the left
until it lightly touches the stack of paper
without bending the paper. The paper
must fit squarely and firmly between the
Paper Width Guide and the right side of
tray. If it does not, the paper may feed
into the printer incorrectly resulting in a
paper jam.
Caution: Make sure that the paper is set
LTR
A4
LGL
2. Replace the Paper Cassette Cover to the
appropriate paper position (LTR, A4 or
LGL).
3. Slide the Paper Cassette into the machine.
The Recording Paper Size setting of the Fax
Parameter No. 23 must match the paper
loaded in the cassette. If you change the
Recording Paper Size, please change the
setting accordingly.
256
under the metal Paper Separation
Clips and that it does not exceed
the Maximum Paper Capacity
Mark. You can load about 250
sheets (20 lb weight).