Table of Contents
Advertisement
Adjusting the Paper Cassette for the Paper Width
How to Adjust the Paper Cassette for the Paper Width
The factory default Paper Width setting for the Paper Cassette is on Letter/Legal size. To change the paper
width to A4 size, follow the steps below.
1
Paper Separation Clip
2
Paper
Width Guide
Max. Paper
Capacity Mark
3
1. If you forget to change the Recording Paper Size setting in Fax Parameter No. 23 when
NOTE
different paper is installed in the cassette, the unit will Stop printing after the 1st page of an
Incoming Fax and display a "PAPER SIZE MISMATCH" error. Then, the Recording Paper
Size setting automatically adjusts to the proper size and the unit resumes printing the Incoming
Fax from the 1st page.
1. Release the left Paper Separation Clip
latch.
2. Pull up the Paper Separation Clip to
remove it.
3. Reposition the Paper Separation Clip
into the A(A4) slot.
4. Swing the Paper Separation Clip
downward to latch it in place.
1. Load the paper into the Paper Cassette.
Slide the paper width guide to the left
until it lightly touches the stack of paper
without bending the paper. The paper
must fit squarely and firmly between the
Paper Width Guide and the right side of
the tray. If it does not, the paper may
feed into the printer incorrectly resulting
in a paper jam.
Caution: Make sure that the paper is set
LTR
A4
LGL
2. Replace the Paper Cassette Cover to the
appropriate paper position (LTR, A4 or
LGL).
3. Slide the Paper Cassette into the
machine.
The Recording Paper Size setting of the Fax
Parameter No. 23 must match the paper
loaded in the cassette. If you change the
Recording Paper Size, please change the
setting accordingly. (See page 79)
under the metal Paper
Separation Clips and that it
does not exceed the Maximum
Paper Capacity Mark. You can
load about 250 sheets (75g/m
weight). For paper
specification, see page 241.
39
2
Advertisement
Table of Contents
