Adjusting The Paper Cassette For The Paper Length; How To Adjust The Paper Cassette For The Paper Length - Panasonic DX-600 Network Fax Manual

Panasonic facsimile operating instructions
Hide thumbs Also See for DX-600:
Table of Contents

Advertisement

Adjusting the Paper Cassette for the Paper Length

How to Adjust the Paper Cassette for the Paper Length

The factory default Paper Length setting for the Paper Cassette is on Letter size. To change the paper
length to A4 or Legal size, follow the steps below.
1
Max. Paper
Capacity Mark
2
NOTE
38
Paper Length Guide
Paper Width Guide
1. If you forget to change the Recording Paper Size setting in Fax Parameter No. 23 when
different paper is installed in the cassette, the unit will Stop printing after the 1st page of an
Incoming Fax and display a "PAPER SIZE MISMATCH" error. Then, the Recording Paper
Size setting automatically adjusts to the proper size and the unit resumes printing the Incoming
Fax from the 1st page.
1. Remove the paper from the Paper
Release Latch
2. While pushing down on the release latch,
3. Turn the Paper Cassette upright.
4. Insert the Paper Length Guide hooks into
5. Load the paper into the Paper Cassette.
LTR
A4
LGL
6. Replace the Paper Cassette Cover to the
7. Slide the Paper Cassette into the
The Recording Paper Size setting of the Fax
Parameter No. 23 must match the paper
loaded in the cassette. If you change the
Recording Paper Size, please change the
setting accordingly. (See page 79)
Cassette and place the cassette upside
down on a flat surface.
pull out the Paper Length Guide.
the appropriate paper length slots (A4 or
Legal) and slide the guide towards the
back of the cassette until it locks in place.
Slide the paper width guide to the left
until it lightly touches the stack of paper
without bending the paper. The paper
must fit squarely and firmly between the
Paper Width Guide and the right side of
the tray. If it does not, the paper may
feed into the printer incorrectly resulting
in a paper jam.
Caution: Make sure that the paper is set
under the metal Paper
Separation Clips and that it
does not exceed the Maximum
Paper Capacity Mark. You can
load about 250 sheets (75g/m
weight). For paper
specification, see page 241.
appropriate paper position (LTR, A4 or
LGL).
machine.
2

Advertisement

Table of Contents
loading

Table of Contents