Adjusting The Paper Cassette For The Paper Length; How To Adjust The Paper Cassette For The Paper Length - Panasonic UF-6300 Operating Instructions Manual

Adjusting the Paper Cassette for the Paper Length

How to Adjust the Paper Cassette for the Paper Length

The factory default Paper Length setting for the Paper Cassette is A4 size. To change the paper length to
Letter or Legal size, follow the steps below.
1
Max. Paper
Capacity Mark
2
Set it with the Control Panel of the machine.
NOTE
22
Paper Length Guide
Paper Width Guide
1. If you forget to change the Recording Paper Size setting in Fax Parameter No. 23 when
different paper is installed in the cassette, the unit will Stop printing after the 1st page of an
Incoming Fax and display a "PAPER SIZE MISMATCH" error. Then, the Recording Paper Size
setting automatically adjusts to the proper size and the unit resumes printing the Incoming Fax
from the 1st page.
1. Remove the paper from the Paper
Release Latch
2. While pushing down on the release latch,
3. Turn the Paper Cassette upright.
4. Insert the Paper Length Guide hooks into
5. Load the paper into the Paper Cassette.
Caution:
LTR
A4
LGL
6. Replace the Paper Cassette Cover to the
7. Slide the Paper Cassette into the
The Recording Paper Size setting of the Fax
Parameter No. 23 must match the paper
loaded in the cassette. If you change the
Recording Paper Size, please change the
setting accordingly in the Parameter No.23
(REC. PAPER SIZE). (See page 37)
Cassette and place the cassette upside
down on a flat surface.
pull out the Paper Length Guide.
the appropriate paper length slots (Letter
or Legal) and slide the guide towards the
back of the cassette until it locks in place.
Slide the paper width guide to the left
until it lightly touches the stack of paper
without bending the paper. The paper
must fit squarely and firmly between the
Paper Width Guide and the right side of
tray. If it does not, the paper may feed
into the printer incorrectly resulting in a
paper jam.
Make sure that the paper is set
under the metal Paper
Separation Clips and that it does
not exceed the Maximum Paper
Capacity Mark. You can load
about 250 sheets (75g/m²
weight). For paper specifications.
(See page 153)
appropriate paper position (LTR, A4 or
LGL).
machine.