Releasing The Bellows From The Front Panel; Removing The Door Safety Switch - Electrolux 6000 series Service Manual

Releasing the bellows (door boot) from the
front panel:
The front of the bellows is installed over the lip of the door
opening in the front panel and held in place by a spring
loaded wire loop.
1. Open the loading door.
2. Using needle nose pliers, start where the spring and
wire are connected at the bottom of the bellows and
pull the wire out of the groove of the bellows.
3. Pull the bellows off of the lip of the front panel.

Removing the door safety switch:

1. Disconnect the washer from the electrical supply.
2. Release the bellows from the front panel.
3. Remove the (2) screws securing the switch
assembly to the front panel.
72