3. Disconnect the wire harness and remove the screw
securing the tab on the side of the control board to
the base. Lift the side of the housing up, slide the
assembly to the rear to disengage the front tab and
lift the assembly away from the washer base.
4. From the front of the washer tip the bottom of the
assembly toward the motor and slide the assembly
out between the shock absorber and the motor.
5. Release the latch on each end of the speed control
housing and raise the top flap.
6. Disconnect the (2) plugs & the ground wire and
remove the speed control assembly from the
washer.
92