1B. Cleaning The Transfer Blade; Opening The Transfer Belt Assembly - Canon 1000 Service Manual

1b. Cleaning the Transfer Blade

1) After removing the transfer blade as in step 5),
stand the transfer blade assembly [1] on its
end as shown in Figure 4-405Ab; then, wipe
the blade [2] and the plastic film [3] with lint-
free paper with bottom-to-top motions or clean
it with a blower brush.
[1]
Figure 4-405Ab
2. Opening the Transfer Belt
Assembly
1) Remove the hopper left cover and the
separation charging assembly, and install the
transfer frame metal fixing [1] to the front side
plate.
Figure 4-406A
2) Remove the two screws, and remove the pre-
transfer cover.
COPYRIGHT © 2001 CANON INC.
[3]
[2]
[1]
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. MECHANICAL SYSTEM
3) While pulling the lever [3] toward the front, set
the transfer releasing lever [4].
[4]
Figure 4-407A
4) Turn the cam [5] by hand so that the belt unit
[6] is in up position.
[6]
Figure 4-408A
[3]
[5]
4-43