Grooming Reel - Toro Greensmaster 3150 Service Manual

Grooming Reel

21
16
9
11
12
10
13
Antiseize
Lubricant
RIGHT
FRONT
1. Lock nut (4 used)
2. Drive cover
3. Groomer drive belt
4. Drive pulley
5. Shoulder bolt (2 used)
6. Spring
7. Drive plate assembly
8. Groomer shim
9. RH groomer arm assembly
Remove the grooming reel to replace individual blades,
to replace worn groomer components, to reverse the
blades on the shaft or to replace the grooming shaft.
NOTE: The drive assembly for the grooming reel is lo-
cated on the left side of the cutting unit (opposite from
the hydraulic cutting reel motor).
Groomer
14
17
20
22
23
26
24
10. Cap screw (2 used)
11. Bushing (2 used)
12. Spring washer (2 used)
13. Lock nut (2 used)
14. Support plate
15. LH groomer arm assembly
16. HOC washer (2 used)
17. RH cutting unit sideplate
18. LH cutting unit sideplate
22 20
13
12
11
16
15
21
10
25
Figure 4
Removal (Fig. 4)
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Remove the cutting unit from the machine and place
cutting unit on a flat work area.
Page 8 - - 8
100 ft- -lb
(135 N- -m)
18
8
7
6
5
19
1
2
17 to 21 ft- -lb
(24 to 28 N- -m)
19. Driven pulley
20. HOC screw (2 used)
21. HOC nut (2 used)
22. Plow bolt (2 used)
23. Grooming reel assembly
24. Front roller assembly
25. Ball stud (2 used per roller)
26. O- -ring
Greensmaster 3150
4
3
1