Toro Greensmaster 3150 Service Manual page 235

Disassembly (Fig. 16)
1. Remove flange nut (item 2) that secures lift arm to
HOC groomer arm. Remove lock nut (item 16) and
spring washer (item 17) that secure lift arm to side plate.
Loosen lock screw (item 6) completely.
2. Remove lift arm from cutting unit.
3. Disassemble lift arm using Figure 16 as a guide.
NOTE: Right and left side HOC groomer arms (item 1)
and lift arm assemblies (item 8) are different; other com-
ponents shown in Figure 16 are the same on both sides
of cutting unit.
NOTE: Grooved pin (item 3) is used to retain lock screw
(item 6) to lift arm assembly.
Greensmaster 3150
Assembly (Fig. 16)
1. Assemble lift arm using Figure 16 as a guide.
2. Apply antiseize lubricant to threads of groomer lift
rod (item 5) and lift arm assembly stud (item 8).
3. Install lift arm onto cutting unit. Secure with flange nut
(item 2) and lock nut (item 16) with spring washer (item
17).
4. Secure groomer in raised or lowered position with
lock screw (item 6).
5. Check and adjust grooming reel height and mower
height--of--cut settings.
Page 8 - - 17 Groomer