Setting The Wireless Remote Controllers - Mitsubishi Electric PAR-WT40R-E Installation And Setting Manual

Place the wireless receiver on the fixed brack-
et.
Hook the holes on the back of the wireless re-
ceiver onto the projections on the bracket, and
fix the wireless receiver.
<Notice>
● Do not place the wireless receiver inside the hydrobox unit.
►Both the wireless receiver and the hydrobox unit may break down, produce heat, and
the wires may break.
● Do not pull the cable excessively.
►Breakdown, ignition, or fire may result.
● Do not have the wireless receiver suspended.
►Breakdown, ignition, or fire may result.
Close the electrical box cover, and fix it with the screws.
Hold the front panel with the screws.

5. Setting the Wireless Remote Controllers

● Pairing of the wireless remote controllers and the wireless receiver enables the
wireless remote controllers to communicate with the wireless receiver. The indoor
unit can then operate from the wireless remote controllers.
● Before using the wireless remote controllers, always ensure that the room wireless
remote controllers go through a pairing process.
Holding down the
simultaneously for at least 3 seconds goes
to the setting mode, which blinks the mode
number (room temp. display).
, and buttons
10