Switching The Temperature Unit; Communication Test - Mitsubishi Electric PAR-WT40R-E Installation And Setting Manual

5.3. Switching the Temperature Unit (Mode No. : 2)
The unit used to display temperature can be
switched between Celsius (°C) and Fahrenheit (°F).
Press the or
the set temp. display uses and press the
ton to confirm the selection.
The set temperature and room temperature
are to use the same unit to show tempera-
tures.
* The figure to the right shows the display when
Celsius (°C) is used.
5.4. Communication Test (Mode No. : 3)
Communication test is performed between the
wireless remote controller and the wireless re-
ceiver.
The set temp. display shows the communication
status is OK or NG. When the display shows "
this indicates that the wireless remote controller is
available for communication with the wireless re-
ceiver. If " " is shown, the wireless remote con-
troller is outside the communication range of the
wireless receiver.
Do not place the wireless remote controller in a
location where the communication test results in
" ".
When the wireless remote controller is not paired, a communication error results even
in the test mode. When testing communication in the test mode, ensure in advance
that the wireless remote controller goes through a pairing process.
button to select the unit that
but-
",
14