Connecting To The Hydrobox Unit - Mitsubishi Electric PAR-WT40R-E Installation And Setting Manual

4.2 Connecting to the Hydrobox unit

* Before installation, be sure to turn off the
main power supply.
Remove the two screws that hold the front
panel, and remove the panel.
Remove the four screws to remove the electrical box cover.
Screws
(2 positions)
Route the receiver's cable into the hy-
drobox unit through the opening on the
underside of the unit. Then route into
the electrical box through any of the
shown openings on the underside of
the box.
Do not bundle the receiver's cable
together with a power cable or run
the cable through an opening that a
power cable goes through.
Front panel
Screws
(2 positions)
Control board
Electrical box
Any of these 2 openings
Electrical box cover
Screws
(2 positions)
8