Brother HL-L9200CDWT User Manual page 57

Driver and Software
Colour Calibration
The output density of each colour may vary depending on the temperature and humidity of the machine's
environment. This setting helps you improve colour density by letting the printer driver use the colour
calibration data stored in your machine.
 Use Calibration Data
If you select this check box, the printer driver will use the calibration data retrieved from the machine to set
colour matching in the printer driver. This will ensure consistent print quality.
Get Device Data Automatically

If you select this check box, the printer driver will use the colour calibration data from your machine.
 Start Colour Calibration
If you click this button, your machine will start the colour calibration process, and then the printer driver will
use the calibration data from your machine.
Sleep Time
When the machine does not receive data for a certain period of time, it enters Sleep mode. In Sleep mode,
the machine acts as though it were turned off. When you choose Printer Default, the timeout setting will be
reset to the specific time set at the factory; this can be altered in the driver. Intelligent Sleep mode adjusts to
the most appropriate timeout setting depending on the frequency of your machine use.
While the machine is in Sleep mode, the Touchscreen's backlight turns off, but the machine can still receive
data. Receiving a print job will wake up the machine to start printing.
Improve Print Output
This feature allows you to improve a print quality problem.
 Reduce Paper Curl
Select this setting to reduce paper curl.
If you are printing only a few pages, you do not have to choose this setting. We recommend changing the
printer driver setting in Media Type to a thin setting.
NOTE
This operation will decrease the temperature of the machine's fusing process.
 Improve Toner Fixing
Select this setting to improve the toner fixing capabilities. If this selection does not provide enough
improvement, change the printer driver setting in Media Type to a thick setting.
NOTE
This operation will increase the temperature of the machine's fusing process.
2
2
2
2
48