Simple Recording Timer - Sharp DV-NC55U Operation Manual

Simple Recording Timer

The Simple Recording Timer (SRT) enables you to set the recording
stop time. The SRT can be set on the TV screen by using the remote
control.
The SRT cannot be set if the clock has not been set. Make sure
the clock is set before setting the SRT.
Preparations
• See Preparing to Use VCR on page 52.
• Insert a cassette with the erasure protection tab opening covered.
• If necessary, set "SAP" on the menu screen. (See MTS (Multi-
channel TV Sound) Broadcasts Recordings on page 64.)
Example: Recording a TV program in the SP mode. The program is
on Channel 2, ending at 9:50 AM. The present time is
8:43 AM.
1
Select the desired channel with the number buttons or CH
' / ".
(Example) Channel → 02
2
Set the recording speed (SP or EP) with TAPE SPEED.
(Example) SP
S P
Recording Speed
3
Press Æ Æ Æ Æ Æ REC to enter the recording mode.
Then, press Æ Æ Æ Æ Æ REC again to enter the simple recording timer
mode. The recording stop time is displayed.
(Example) 8:50 AM
S P
4
Each press of Æ Æ Æ Æ Æ REC increases the stop time by 10 minutes.
(Example) 9:50 AM
S P
5
When the stop time comes, recording is finished, and the power
turns off.
0 2
0 2
S T O P 8 : 5 0 A M
0 2
S T O P 9 : 5 0 A M
TIMER
POWER
TV/VCR EJECT
ON/OFF
ON VCR/DVD VCR MENU
DISPLAY
SCREEN SELECTOR DVD SETUP
OPEN/
FUNCTION
PROGRAM ZOOM
CONTROL CLOSE
TITLE
DVD MENU
CANCEL SET
RETURN
ENTER
ZERO BACK
SKIP SEARCH
REPLAY
Number
AM/PM INPUT VCR DVD
buttons
100
REV FWD
PLAY
REC
PAUSE/STILL
STOP
TAPE DPSS
SKIP SLOW TAPE
SPEED
SPEED
AUDIO
CH
OUTPUT
VCR DVD
CH
VCR/DVD COMBINATION
REC
/
65