Dell 2130cn User Manual page 163

1
* Available when POP before SMTP for E-Mail Send Authentication is selected.
SNMP
Purpose:
To configure the detailed settings of SNMP.
Values:
Enable SNMP v1/v2c Protocol Select the check box to enable the SNMP v1/v2c protocol.
Edit SNMP v1/v2c Properties
Enable SNMP v3 Protocol
Edit SNMP v3 Properties
NOTE: An optional network protocol adapter is required to display the SNMP page.
SNMP v1/v2c
Purpose:
To edit the detailed settings of SNMP v1/v2c protocol.
To enter this page, click Edit SNMP v1/v2c Properties in the
Values:
Community Name (Read
1
only)*
Re-enter Community
1
Name (Read only)*
Community Name
1
(Read/Write)*
Re-enter Community
Name (Read/Write)*
Community Name
1
(Trap)*
Re-enter Community
1
Name (Trap)*
Trap Notification 1-4
Authenticate Error Trap
1
* The default value of each items can be changed by using Dell Printer Configuration Web Tool.
SNMP v3
Purpose:
To edit the detailed settings of SNMP v3 protocol.
To enter this page, click Edit SNMP v3 Properties in the
Values:
Downloaded from ManualsPrinter.com Manuals
Click to display SNMP v1/v2c
Select the check box to enable the SNMP v3 protocol.
Click to display SNMP v3 page and to edit the setting of SNMP v3 protocol from the page.
Without SSL communication is enabled, you cannot click this item.
SNMP
Specifies the community name to access (read only) data using up to 31 alphanumeric characters.
The original setting will remain valid if no input is made. Characters entered for community name in the previous settings will not
be displayed on the screen. The default Read Community is public.
Enter the community name to access (read only) data again to confirm it.
Specifies the community name to access (read and write) data using up to 31 alphanumeric characters.
The original setting will remain valid if no input is made. Characters entered for community name in the previous settings will not
be displayed on the screen. The default Read/Write Community is private.
Enter the community name to access (read and write) data again to confirm it.
1
Specifies the community name used for trap up to 31 alphanumeric characters.
The original settings will remain valid if no input is made. Characters entered for Community Name (Trap) in the previous settings
will not be displayed on the screen. The default Trap Community is " " (NULL).
Enter the community name used for trap again to confirm it.
Select the check boxes to notify trap occurrence. In this case, specify the IP address and IP socket in the following format:
IPv4
l
Specify the IP address and IP socket in the nnn.nnn.nnn.nnn:mmmmm format. Each section of "nnn" is a variable value between 0
and 255. Note that values 127 and 224-254 are not valid for the first three-digits only. IP socket mmmmm is a variable value
between 0 and 65535.
IPv6
l
Specify the IP address and IP socket in the xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:mmmmm format. Each section of "xxxx" is a
hexadecimal variable value between 0 and ffff. IP socket mmmmm is a variable value between 0 and 65535.
Select the check box to notify Authenticate Error Trap.
SNMP
Account Enabled
User Name
page and to edit the setting of SNMP v1/v2c protocol from the page.
page.
page.
Select the check box to enable the administrator account.
Enter the user name of the administrator account.