NEC SL1100 Installation Instructions Manual page 15

Part 2: Using a Phone to Assign the IP Addresses to the SL1100
Requirements:

A phone connected to the SL1100 Phone System

The three (3) IP Addresses that you wrote down in Part 1
UNPLUG THE SL1100 FROM ALL ETHERNET CONNECTIONS!
From a phone connected to the SL1100:
1.
Press the Speaker Button.
2.
Press # * # * (pound, star, pound, star).
3.
When prompted for a password, Press 12345678.
4.
Press the Menu Key. (The Menu Key is the unmarked Circular Button on the lower right corner on the
front of the phone)
5.
You will now see "Program Mode" on the phone's display.
6.
Using the dial pad, type 10-63-01 to enter DHCP Client Mode. Our pre-programmed system default
has DHCP set to YES. Change this to NO by pressing the black key +1 soft key under the LCD
display. This turns DHCP off.
7.
Press the Menu Key.
8.
Press the Mute key two times to back out of 10-63 programming.
9.
Using the dial pad, type 10-12-01. You'll be asked to enter the IP Address of the SL1100, so refer to
the number you wrote down in Part 1, and type your SL1100 System IP Address.
10.
You'll automatically be entered into Programming Mode 10-12-02, where you will be asked to enter a
Subnet Mask. Refer to the number you wrote down in Part 1, and type your Subnet Mask IP
Address, then Press the Menu Key.
11.
You'll automatically be entered into Programming Mode 10-12-03 where you will be asked to enter your
Default Gateway. Refer to the number you wrote down in Part 1, and type your Default Gateway IP
Address.
1-888-632-3794 • info@necsl1100distributors.com
SL1100 Installation Instructions
4