Grooming Reel - Toro 04384 Service Manual

Grooming Reel

100 ft- -lb
(135 N- -m)
17
18
4
1
2
20
16
21
1. Lock nut (4 used)
2. Drive cover
3. Groomer drive belt
4. Drive pulley
5. Shoulder bolt (2 used)
6. Spring
7. Drive plate assembly
8. Groomer shim
9. RH groomer arm assembly
Remove the grooming reel to replace individual blades,
to replace worn groomer components, to reverse the
blades on the shaft or to replace the grooming shaft.
NOTE: The drive assembly for the grooming reel is lo-
cated on the opposite side of the cutting unit from the hy-
draulic cutting reel motor. Figure 4 shows the grooming
reel drive on the right side of the cutting unit.
Groomer
25
8
6
11
7
19
1
5
3
9
10
Figure 4
10. Cap screw (2 used)
11. Bushing (2 used)
12. Spring washer (2 used)
13. Lock nut (2 used)
14. Support plate
15. LH groomer arm assembly
16. Special washer (2 used)
17. Rear roller height shim
18. Socket head screw (4 used)
Page 8 - - 8
26
22
23
27
13
12
17 to 21 ft- -lb
(24 to 28 N- -m)
19. Driven pulley
20. HOC screw (2 used)
21. HOC nut (2 used)
22. Plow bolt (2 used)
23. Grooming reel assembly
24. Front roller assembly
25. RH cutting unit sideplate
26. LH cutting unit sideplate
27. O- -ring
Removal (Fig. 4)
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Remove the cutting unit from the machine and place
cutting unit on a flat work area.
14
15
11
12
13
Antiseize
Lubricant
24
RIGHT
FRONT
Greensmaster 3250--D