Toro 04384 Service Manual page 241

Hide thumbs Also See for 04384:
Table of Contents

Advertisement

4. Remove grooming reel bearings and seals from
drive plate and support plate assemblies (Fig. 11):
A. Remove seals from groomer plates. Discard re-
moved seals.
B. Press bearings out of side plate housings. Dis-
card removed bearings.
Bearing Installation
1. Install new grooming reel bearings and seals into
drive plate and support plate assemblies (Fig. 14):
IMPORTANT: Bearings should be installed with ex-
tended inner races toward center of housing. Also,
apply pressure equally to inner and outer bearing
races when installing bearings.
A. Press new outer bearing fully to shoulder of drive
plate bore. Then, install new inner bearing until inner
race contacts outer bearing race.
B. Press new bearing into support plate until it is
flush with shoulder of bearing bore.
C. Install new seals into side plates. NOTE: Seals
should be installed so the lip side of the seal will face
the center of the cutting reel. When bearings are
greased, grease will purge from inner seals.
2. Install support plate to cutting unit:
A. Apply antiseize lubricant to threads of LH groom-
er arm lift rod.
B. Position support plate to cutting unit making sure
that LH groomer arm lift rod is positioned through
bushing in support plate.
C. Place spring washer and lock nut on lift rod
threads (Fig. 13). Tighten lock nut.
D. Position motor mount to groomer support plate
(Fig. 12). Secure motor mount and support plate to
cutting unit with two (2) socket head screws and lock
nuts.
3. Install grooming reel, front roller and drive plate to
cutting unit (see Grooming Reel Installation in this sec-
tion).
4. Check and adjust grooming reel height and mower
height--of--cut settings.
5. Install cutting unit to the machine.
6. Lubricate groomer bearings.
NOTE: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe any ex-
cess grease from groomer shaft and seals.
Greensmaster 3250--D
3
1
1. Socket head screw
2. Motor mount
3. Groomer side plate (RH)
1
4
1. Roller cap screw
2. Grooming reel assembly
3. Lock nut
6
8
1. Outer bearing
2. Drive plate shoulder
3. Inner bearing
4. Inner race
Page 8 - - 13
4
2
1
Figure 12
4. Cutting unit
5. Lock nut (2 used)
5
2
3
Figure 13
4. Spring washer
5. Groomer arm lift rod
2
3
5
5
4
7
Figure 14
5. Seal lip
6. Support plate bearing
7. Drive plate
8. Support plate
Groomer
5
1
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Greensmaster 3250-d

Table of Contents